Waterjet Cutting Cost
You will realize that so many people have fallen for waterjet cutting. It is not uncommon for someone to pursue understanding the aspect of waterjet cutting cost. You will find it necessary to understand that so many different costs are attached to this waterjet cutting process. It is necessary to indicate that there are a number of variables as well as power requirements that will need to be taken into consideration. Water and abrasive will also come at a cost too. There are basically six different configurations known. They attract different costs. It is for this reason that it will be valuable for you to understand some of the costs attracted by this waterjet cutting. They will every so often include the following.
There is a cost attached to water. You will actually find that this is what will cost you the least among all. This water will be effective in cutting as well as cooling. In most cases, 3.5 dollars will be spent on a 1000 gallon. This will go ahead to cost you a figure of between 1200 and 2500 dollars each year. It is imperative to mention that there will be a need for you to pay an extra amount for the sewer as well. This will often depend on your location. There are regions that will cost more than the others. You will learn that the intensifier pump will also have to be run. This will often need power. You will learn that it will be required of you to use around 3700 to 9400 dollar annually for power. This will however depend on the usage. These figures are actually premised on pumps that come with about 50 to 125HP.
There is also a cost attached to abrasive. It will often turn out to be the most costly of all. You will realize that there are usually two main types of garnets available. You will find that there is usually the alluvial as well as the hard rock garnet. You will realize that hard rock is appreciated as being sharper. This is what will make it tend to cut faster. You will note that the alluvial garnet will be characterized by rounded grains. This means that you will need to pay more for the hard rock. It is also important for you to pay attention to the expenses attracted by the abrasive flow rate. It will often cost you between 26000 and 55000 dollars annually.
There is a need for you to consider the cost of wear and tear too. Replacement of certain parts such as orifice will be quite common. There are also miscellaneous pump part costs. You can spend on them up to 32000 dollars each year.